![]() On CA Certificate, click the folder icon and browse to the ca. Enter your FrootVPN username and password. Call it FrootVPN 1194 and use for the Gateway. Then, “ifconfig” or “ip address” command and your ip information, and“ route ”or“ netstat -nr ”command by looking at our routing table can verify the connection. Click on the Network Manager icon and go to VPN CONNECTIONS > CONFIGURE VPN. The VPN will ask for the password of the user, enter it as below and say OK and wait for it to connect.Īnd we have received the link successful information.Īfter a successful connection, a lock pattern is formed on the Wifi sign. Click on the Wi-Fi broadcast flag again, then click on VPN Connections and click on our VPN connection. ovpn file in the light of the information determined and say “ OK”.Īfter you say OK, the following information is recorded. Then we select the Cipher option from the Security section as written in the *. ovpn, into the OpenVPN client configurations directory. Therefore, copy your OpenVPN configuration file, either. Then we check the options below, it’s not really necessary, but let’s do it anyway. Running OpenVPN Client as Service on Ubuntu 20.04/18.04 When you install openvpn package, it creates a /etc/openvpn/client/ directory into which you can place the OpenVPN client configuration file. ovpn file as follows and click “ Advanced“. Then we enter the information with the information in the *. ovpn file, we will provide the connection.Ĭlick the Wi-Fi broadcast flag and click Connections Edit Connections… After the GUI configuration is done exactly the same with the information in the *. In the screenshot below I explained in detail. In fact, our main configuration file is *. > sudo openvpn –config fw-TCP-1194.ovpn –daemon –auth-user-pass VpnBilgilerĬonfigure the SIMI as a GUI and provide a connection You can also provide this with the command below. It should be in the directory with the connection information. This may be needed to make your work easier. NOTE2: Even the user and password information from the file without entering the connection can provide. > sudo openvpn –config fw-TCP-1194.ovpn –daemon This can be solved with different attractions, but the most accurate method is to add the “daemon” parameter to the command. NOTE1: After the Vpn connection is made, the terminal will need to remain open, if you close it, the connection will break.
0 Comments
Leave a Reply. |